Free shipping within Germany on orders from €30
Material

Materials with responsibility

An object is only as sustainable as its material. Here is ours — and why we chose it.

plant-based PLA

We print mostly on polylactic acid (PLA), made from renewable raw materials — in our case from sugar sourced from sugar cane and sugar beet. PLA is food-safe, takes colour beautifully and, next to PETG or ABS, is the far cleaner choice for objects you hold in your hand.

At the end of its life PLA can be composted under industrial conditions. A home compost heap never reaches them, so we recommend sending the object back to us or handing it in at a specialised collection point — not the general waste bin.

Two spinning fidgets in shimmering green-blue and purple-blue

Ball bearings

For the spinning and sliding motions we use long-life stainless-steel ball bearings.

Neodymium magnets

Some objects use neodymium-iron-boron magnets for their magnetic snap-back. These magnets are extremely strong, corrosion-resistant and permanently magnetic. They keep their promise for the whole life of the object.

Render of a Wobble8, partly see-through: a ball bearing sits in the joint
Render: the ball bearing in a Wobble8 joint

ABS, where heat is involved

An object sitting close to a lamp socket must not go soft, and that is exactly where PLA gives up, at around 60 °C. Those objects — currently the lamp shade for E27 sockets — are printed in ABS instead. ABS is heat-resistant and durable, but petroleum-based, not compostable and not food-safe: both of those promises apply to our PLA objects only. Every product page states which material that object is made of.

Glowing lampshade with a diamond pattern in front of a window

Specification

Print materialPlant-based PLA (renewable); ABS for objects used near heat
BearingsStainless-steel ball bearings, maintenance-free
MagnetsNeodymium-iron-boron (NdFeB)
Packagingplastic-free, recyclable
Bearings and magnetsglued in place, not meant to be swapped
Massage rollers in front of their cardboard tubes with the haptic3D logo
Promises

What we deliberately do not do

— No single-use plastic.

— No planned obsolescence. We pick the material and the print profile for the highest quality we can reach.

— No overproduction. We print to order, not for the shelf.

— No greenwashing claims. PLA is not perfect — but it is the most honest choice we have today.

Take-back

Object at the end of its life?

Send it back — we take out the bearings and magnets and recycle the plastic.

Arrange a take-back

← Back to the collection